Star Wars Legion Terrain - Tatooine Hut

Making some more Star Wars Legion terrain for the upcoming release. What self respecting Tatooine table top would be with this hut? None I say! Modeled on the Lars Homestead hut entrance from Star Wars, I modeled the original shell in Tinkercad, then dropped it into Meshmixer to sculpt the outside into a more rounded/adobe style outside. Then back to Tinkercad for some more tweaks for printing, adding in the door controls, and entryway details. I also added a sliding door to the model. The major difference between the movie version and this one is that movie version is short because it leads to a set of stairs downwards, so it's not really scaled. I opted to mimic the shape, and not worry about the stairs. I scaled it so a 27mm legion base can fit into the doorway. I also included a Barrel model that I use in my Barricades models based on the barrel seen outside the hut in the movie. Painted in browns and ivory drybrush. Army Painter Tan primer is awesome for these models, btw. Note: the ring around the top on the printed model is from where my printer ran out of filament while it was printing overnight. I printed just the top and glued it on, but was off by a tiny bit. for my purposes it works just fine. Don't worry the ringed bit is not in the model. Just watch your filament, it's a long print. :) If you'd like to purchase a print of this, you can check here are FunBoardGames on Etsy who is the only authorized vendor of these printed models.https://www.etsy.com/shop/FunBoardGames